Broadcasting from everywhere
Live + archived signals
Choose a feeling. We’ll keep the room moving.
59 signals in all
Ready when you are
Generative rhythm system
EditingBar 1 / 8
Tap steps to rewrite the groove live. Mute a voice by tapping its name.
SOUNDS / SAMPLER
Capture a sound. Make it your own.
Count in, record a sound, then keep building. Each pass adds a new layer.
Choose a loop length and count-in, then record. Each pass becomes a separate layer.
The audible count-in stops when recording starts unless you enable the recording metronome. The visual beat guide stays on. Recorded loops play back as you build your performance. Sequencer sounds are off by default. Without headphones, turn off loop playback during recording to reduce speaker bleed; your loops return when recording finishes.
Input: System default microphone. Headphones with a microphone may select the headset mic. Mic gain affects new recordings, not playback volume.
Not measured · automatic estimate in use
Use your phone speaker in a quiet room. Three short tones measure the actual speaker-to-microphone delay. Calibrate again after changing your audio setup. This measurement lasts until the page is reloaded and replaces any manual recording offset.
Device output delay and microphone delay, when reported, are compensated automatically. Use this additional offset to fine-tune your phone: a positive value captures later input, moving the recorded sound earlier against the beat. Wired headphones give the most predictable timing.
12 sound slots available. Only incoming microphone audio is recorded.
Re-record and replace change only this layer. Use + Add new sound to keep it. Record up to 15 seconds. Headphones recommended.
SHAPE YOUR SOUND
Drive adds grit. Tremolo pulses in eighth notes at the project tempo.
Your surroundings are an instrument. Start with a pad.
Your recordings stay in your browser. Save on this device or download a project to keep them. Record taps adds pad hits to the running loop.
